top of page

Essential Information

Notes to the design:
We do not check assembly and we do not check tolerances between the different parts. The sole responsibility for assembly rests with the designing customer.
For easy assembly: keep tolerances between the bodies. Hirch Models will not be responsible for the assembly of parts that were not given appropriate tolerances in the design. Sanding the parts/reprinting with tolerance will be charged and will delay delivery time.

The required tolerance varies according to the technology, and the required level of speed - please consult us about the correct tolerance.


It is recommended to send a BOM table when sending the files - for your convenience, here is a link to the table with the range of available materials and technologies:

https://docs.google.com/spreadsheets/d/1xNGI505MqffXPCBv96950zFWlI3eUSppG6Rv1mmcq-M/copy 


The screws:

Here is a link to the instructions for proper preparation planning for stud-inserts and helical coils: https://docs.google.com/document/d/1RfzQ63FCr_PdcdieRJZ2Qsxq9V_8iM1l4Fa8Zl5VxVc/edit 
The accuracy of the measurements obtained in printing depends on the technology, the size of the part, and the orientation in which it was printed. Please let us know if there is a requirement for special accuracy in critical areas.
If there is a wall of less than 0.8 mm, we would like to draw our attention.


Finishing: without special request, the finishing of the parts is raw (cleaning only)
If finish and color are required: color specification ((Pantone/Ral) and finish (matte/silk matte/glossy) must be provided in an orderly manner for each part. After receiving the specification, the price quote will be completed and a new delivery time will be set.


In soft parts, data must be provided on the hardness (Shor degree) and desired shade of the casting ((Pantone/Ral
Please note that silicone / vacuum forming molds will be kept for the customer's use for 60 days after the end of the project, if the customer does not require them during this time period, the molds will be sent for recycling.

Administrative notes:

The price is without VAT.

If the offer is approved, you must send an order or specify who the paying customer is.

Please send final files when the order is sent, if no final files are sent when the order is sent, the last files sent will go into production.

Tax invoices will be issued by the end of each month, at the latest.

We do not issue credit invoices under any circumstances.

The schedule for this offer is valid for 48 hours. If the approval comes later, a new schedule must be coordinated with Hirch Models.

ISO 9001 standard - quality management system:

https://drive.google.com/file/d/1UJYhn1Bydol1SaRkb7iAnvG8iqnwbCG0/view?usp=sharing

bottom of page